Bracket for the CR10 and E3D Volcano.

Discussion in 'Volcano' started by simonboydfoley, Aug 24, 2019.

  1. simonboydfoley

    simonboydfoley New Member

    Joined:
    Aug 24, 2019
    Messages:
    1
    Likes Received:
    0
    Hi Guys,
    I had a fan failure on my CR10 and it caused me problems with my Micro Suisse All Metal Hotend. I keep getting filament jamming in the heat break.

    The Micro Suisse is of poor quality, and the grub screws have rounded out on the heat break and thermistor hot end block when I tried to strip it down for a reassembly for an acetone cleaning.

    I have a lovely E3D Volcano but I cant print the holding bracket to attach it to the CR10.

    Does anybody know if there is a mounting plate I can buy somewhere to fit the 2 x m3 holes on the CR10S X Axes Plate ?

    I am loath to have to buy another shitty Micro Suisse just to print the bracket for the E3D :-(
     
    #1 simonboydfoley, Aug 24, 2019
    Last edited: Aug 24, 2019

Share This Page