Brief airprinting

Discussion in 'E3D-v6 and Lite6' started by Ralph Hilton, Jul 17, 2014.

  1. Ralph Hilton

    Ralph Hilton Well-Known Member

    Joined:
    Feb 27, 2014
    Messages:
    46
    Likes Received:
    0
    There is a particular problem that I have had a couple of times when the extruder jams then unjams. I have noticed that the cause of this is that the hotend is too close to the bed and that the plastic doesn't have room to get out. Reducing Z home pos by 0.1mm resolved it.
     

Share This Page