Bulldog extruder with volcano hotend not pushing plastic

Discussion in 'Troubleshooting' started by Nick Wolford, May 6, 2020.

  1. Nick Wolford

    Nick Wolford New Member

    Joined:
    May 6, 2020
    Messages:
    1
    Likes Received:
    0
    I"m having consistent issues with my extruder not being able to push the plastic consistently. The hotend seems to be doing its job but the plastic is not being pulled through. I have this on multiple motors / hotend assemblies. It does this at all speeds. I can feel the plastic not being pulled. I have adjusted the tension that the idler puts on the plastic and still nothing. Eventually the drive gear gets clogged with plastic and will not push anything. Any thoughts / comments are welcome!
     

    Attached Files:

Share This Page