Capricorn PTFE

Discussion in 'General' started by Montague Flange, Oct 21, 2017.

  1. Montague Flange

    Montague Flange Active Member

    Joined:
    Jul 10, 2016
    Messages:
    34
    Likes Received:
    6
    Do you sell it on it's own ?
     
  2. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    561
    Likes Received:
    75
    With sizes and where it is used? (Like inside the 1.75 mm V6 filament heat sink)

    A list of coming soon would be good, like the hot end heater with a connector at the extruder end. Making removal of all parts, print cooling fan, heat sink fan and thermistor easy when disassembling so connections are not broken when trying to extract parts from the heater block.
     

Share This Page