Chimera+ Aqua

Discussion in 'Multi-Extrusion' started by hevilp, Aug 15, 2018.

  1. hevilp

    hevilp New Member

    Joined:
    Aug 15, 2018
    Messages:
    1
    Likes Received:
    0
    Hi,

    how is temperature of the heatsink (the water reservoir) when the watercooling is running?

    If I heat up to 220°C I cannot touch the surface of the heatsink anymore.
    I think if I will do longer prints, my hotend holder will melt, even it is PETG.

    How do I check, if the pump is running right? The fan runs without any problems, but bubble in the tubes does'nt move, I think the pump is broken.
     
  2. mhe

    mhe Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    129
    Likes Received:
    32
    If in doubt, install a flow meter. It makes flow visible. But if it overheats like that, chances are your pump may be broken.
     

Share This Page