Hi, I'm considering upgrading my CR-10S with a Chimera+. To do that I'll obviously need to manufacture a new mount. As such, I had a look at the drawings for the Chimera on your doc-site, but I didn't see any information about the Chimera and Chimera+ being close enough for those drawings to be usable for the Chimera+. Could you please confirm if they are? Also, I'm a bit worried that the hot ends draw too much power for the stock PSU of the CR10, can you provide information the regarding the power usage? Lastly, what type are the temperature sensors shipped with the Chimera+? Edit: What lengths are the tubes shipped with your water cooling kit? I'm thinking of building an enclosure so I'd need to place the tank some distance away from the printer.
I'm looking for the drawings too. I already purchased and wanted to design a mount for my CR-10, but I think I have to wait until my chimera+ (air cooled) arrives so that I can measure everything manually.
https://e3d-online.dozuki.com/Document/p3XA6cEBbARPEHkt/.pdf 30w heaters and cartridge thermistors stock
Thanks, elmoret. What about the lengths of the tubes for the Water Cooling Kit? Do you have specs for those as well, would be good to know what to buy if I need to extend them.
