Chimera Spare Parts

Discussion in 'Multi-Extrusion' started by danielogc, May 4, 2017.

  1. danielogc

    danielogc Member

    Joined:
    Aug 27, 2015
    Messages:
    9
    Likes Received:
    0
    I broke the Heat Break and Nozzle on my Chimera when I over tightened them. First I broke the brass nozzle with the threaded part jammed in the heater block. I though I could reuse the heater block first by removing the heat break and the heat break also broke.

    I am now out of pocket for a new replacement set but it seems that there are no more spare parts for Chimera or am I missing something?

    So the heater block and nozzle are the same as that from V6? That's fine but what about the Heat Break?
    Is the Heat Break the same as that of the Cyclops?

    This raises another question. Is Chimera obsolete and if the spare parts of Cyclops are still available does this tell me that Cyclops is better for dual extrusion than Chimera?
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    586
    Likes Received:
    91
    Chimera uses the same heater block and nozzle as v6. Chimera uses the same heatbreak as Kraken, and those are available as well. E3D and most of their distributors should carry those parts.
     

Share This Page