SOLVED Communications problem over USB

Discussion in 'Calibration, Help, and Troubleshooting' started by joea, Oct 27, 2022.

  1. joea

    joea Member

    Joined:
    Nov 12, 2019
    Messages:
    23
    Likes Received:
    0
    Having difficulty getting BB to connect with MC (Matter Control) via USB.

    I can see some communication M105 sent, but a communications failure. I am certain it is not the USB port of the printer or the cables as I have done the "due diligence" thing in swapping things around, cables, ports, another printer, and it comes down to the BB.

    According to Arduino, it successfully uploaded the latest firmware and I can see x,y.z position alternating between "?" and "0", perhaps as it has not zeroed yet?

    The version of MC I have is from Robo 3d for the R1.

    Are there other slicer/printer software I can try out that know the BB?

    Any suggestions on isolating the issue are welcome as well.
     

Share This Page