Comparisons

Discussion in 'BigBox General Chat' started by Dr Jeep, Sep 9, 2016.

  1. Dr Jeep

    Dr Jeep Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    530
    Likes Received:
    169
    It's easy to forget how easy my BB and a few enhancements like Print Bite (which is performing miracles for me at the moment) have improved my 3D printing experience.

    I've been recommissioning my old K8200 to give to a new owner to get started on. It feels positively stone age now compared to my BigBox.

    The manual bed levelling and Z home which is so sensitive, thermal expansion of the frame throws it out, the icky Z drive setup, The inability to correctly tension any belts....grrr I've spent a day swearing at this thing trying to get it back in fit state after a partial rewire.

    Actually started wondering if I was helping a kid get into this 3D printing lark or providing a mechanism to put him off engineering for life :)
     
    eca, mike01hu and Ben Bajorek like this.

Share This Page