Correct motor wiring for SKR 2 board

Discussion in 'HotEnds & Extruders' started by ozcam, Aug 20, 2021.

  1. ozcam

    ozcam New Member

    Joined:
    Aug 18, 2021
    Messages:
    1
    Likes Received:
    0
    I am somewhat confused with conflicting information about how to correctly wire the e-motor on my SKR 2 board. Below is the pinout for the extruder motor
    [​IMG]
    Looking at the stepper motor datasheet, I have assigned in red where I think each pin should go.
    Does this look correct?
    [​IMG]
    If all this is correct

    Then the wiring order for the SKR 2 board should be from L - R

    Black Red Blue Green
    [​IMG]

    Can anyone please confirm that my logic here is correct?
     

Share This Page