CR-10s pro V2 Hemera Upgrade: Config questions!

Discussion in 'HotEnds & Extruders' started by Steve Uckerman, Oct 1, 2021.

  1. Steve Uckerman

    Steve Uckerman New Member

    Joined:
    Oct 1, 2021
    Messages:
    1
    Likes Received:
    0
    Hi There!
    I am completing an install of a Hemera on my CR-10s Pro V2 with a bltouch probe.

    Question:
    What are the next steps for configuration?
    Modify the Creality settings (via Pronterface?) for temp, offset, etc.. Or use a FW build from Insanity automation, etc.. Help?

    Steve
     

Share This Page