Cura profiles for Bigbox

Discussion in 'Guides, Mods, and Upgrades' started by cez, Apr 8, 2019.

  1. cez

    cez Well-Known Member

    Joined:
    Apr 4, 2016
    Messages:
    131
    Likes Received:
    23
    Does anybody use Cura? if so would it be possible to have a look at your Bigbox profile as a starting point to building my own?
     
  2. gonzalo

    gonzalo Well-Known Member

    Joined:
    Mar 17, 2016
    Messages:
    255
    Likes Received:
    146
    I am sure it is possible I did run cura with one extruder only, and bcn3d sigma uses cura with Idex so all configurations are possible under cura, but I have not seen anybody actually using it by default on a BB.
     
    cez likes this.

Share This Page