Cyclops and marlin...

Discussion in 'Multi-Extrusion' started by Farmer, Nov 17, 2018.

  1. Farmer

    Farmer Member

    Joined:
    Nov 17, 2018
    Messages:
    2
    Likes Received:
    0
    hey all
    I have a Creality CR-10s, board version v2.1 and i use Marlin 1.1.9.
    Now I've rebuilt my CR-10s with an E3D Cyclops and two Titan extruder.

    My problem E0 works but E1 does not move.
    I have already tested different firmware with different configs, but always the same problem. I have already read all forums, contributions and anything else.

    Maybe somebody can help me. Thanks (sry for bad english)
     
  2. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    700
    Likes Received:
    91
    One nozzle turned off (not enabled) in the slicer ?
     
  3. Farmer

    Farmer Member

    Joined:
    Nov 17, 2018
    Messages:
    2
    Likes Received:
    0
    I tried it only on the control panel but E1 does not work. I have not set anything in the slicer because E1 does not even work manually
     

Share This Page