Cyclops Watercooled O-Ring size?

Discussion in 'Multi-Extrusion' started by Qdeathstar, Jan 21, 2021.

  1. Qdeathstar

    Qdeathstar New Member

    Joined:
    Jan 21, 2021
    Messages:
    1
    Likes Received:
    0
    Hello,

    Unfortunately my cyclops did not get water while the hotend was powered resulting in filament melting into the cold end. No worries, got the blow torch and cleared it out but silicone o-rings dont particularly like butane fueled infernos and now im stuck with o-rings that dont hold water.

    What is the dimensions of the o-rings so i can order replacements? i know its 4mm id but im not sure about the OD, as my calibers say 1.75?
     

Share This Page