Default nozzle and bowden adapter thread size?

Discussion in 'E3D-v6 and Lite6' started by GeoffS, May 22, 2016.

  1. GeoffS

    GeoffS Member

    Joined:
    Jun 9, 2014
    Messages:
    9
    Likes Received:
    4
    I bought an E3D-V6 nearly 2 years ago for a delta build that never happened so I'm going to install the hotend on my Ord Hadron printer instead.
    A couple of questions:What's the default nozzle size (I think 0.4mm)? What thread is on the bowden plastic pneumatic connector ( the one that connects the PTFE tube to the extruder)?
    As I have a stack of 20x40 extrusion (mostly Makerslide) so I still might build the delta or perhaps just a large cartesian printer.
     
    #1 GeoffS, May 22, 2016
    Last edited: May 22, 2016
  2. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    561
    Likes Received:
    75
    GeoffS likes this.
  3. GeoffS

    GeoffS Member

    Joined:
    Jun 9, 2014
    Messages:
    9
    Likes Received:
    4
    Thanks for that, should have read a bit more before posting.
    Seems I have the 0.4 (standard) and well as a 0.25 and a 0.8.
    I'll stick with the 0.4 for testing as it's the same size as the J-Head I currently have installed.
     

Share This Page