Default of retraction at start of layer

Discussion in 'E3D-v6 and Lite6' started by joyeufetar, Nov 1, 2017.

  1. joyeufetar

    joyeufetar Member

    Joined:
    Oct 31, 2017
    Messages:
    2
    Likes Received:
    0
    Hi,

    I have bought an e3d v6 in direct drive few years ago.
    I have test it in direct drive and bowden but i have same problem in all case.

    I still have problems with retraction.
    At each layer beginning, i don't have sufficient filament (PLA) and after, overextrusion :
    IMG_20171020_103008[1].jpg IMG_20171020_103039[1].jpg IMG_20171101_231112[1].jpg IMG_20171101_231124[1].jpg

    I use Simplify3d and i have test many parameters (speed, quantity, acceleration, jerk...), but problem doesn't disappear.
    Steps/mm are good.

    Do you have any ideas which settings i need to adjust ?

    Thanks in advance,
    Good night
     
  2. dc42

    dc42 Well-Known Member

    Joined:
    Aug 16, 2016
    Messages:
    173
    Likes Received:
    70
    Pressure advance may help.
     
  3. joyeufetar

    joyeufetar Member

    Joined:
    Oct 31, 2017
    Messages:
    2
    Likes Received:
    0
    Hello,
    Thanks for your help, but what does it mean ?
     

Share This Page