SOLVED Did I do something wrong? Pro to Hybrid Pro

Discussion in 'Build Help' started by Steven Burns, Jul 24, 2016.

  1. Steven Burns

    Steven Burns Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    195
    Likes Received:
    55
    Something does not seem right after doing my upgrade to the Hybrid Titan Pro.

    IMG_4237.JPG
    I am losing a ton of the bed if I account to the bed sensor. In the picture the carriage is over as far as it can go, which is 10 on the bed metrics. The sensor hangs over the shelf by quite a lot. If I account for the sensor then the min left starting position is going to be 50. This can't be correct, can it? If it is then I just lost 50 mm of build volume.

    Thoughts?
     
  2. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    All fine. Use a shorter endstop screw to get you hotend to X0...
     
  3. Steven Burns

    Steven Burns Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    195
    Likes Received:
    55
    Thanks. I did change it and just realized that I have not had enough coffee this morning. The head does not move down so it will never get hit by the shelf!!! Wow do I feel like a dope.

    My only issue now is that the sensor cable is actually in the way so I cannot get it to move to zero. Will need to pull and reroute the cable to get at zero, but that should not be much of an issue.

    Thanks
     

Share This Page