Distance between feet if it has any

Discussion in 'BigBox General Chat' started by Stian Indal Haugseth, Oct 20, 2015.

  1. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    573
    Likes Received:
    95
    Hi,

    Does the printer have feet? If so, what's the width between them?

    I'm looking to get a small drawer unit with wheels to put the printer on. But I have only found ones that are 42cm wide. Will the printer fit on this drawer unit or do I have to use a wider plate to support it?
     
  2. Sanjay

    Sanjay Administrator
    Staff Member

    Joined:
    Feb 27, 2014
    Messages:
    125
    Likes Received:
    118
    Just cracked out the tape measure to get this quickly. In the longer direction (X axis direction), the distance from leftmost edge of left foot to rightmost edge of right foot is about 525mm. So you might need a wider drawer!
     
  3. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    573
    Likes Received:
    95
    Thanks Sanjay!

    I'll keep looking or just put a bigger plate on top of the drawer unit :)

    Regards
    Stian
     
  4. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    Is the pattern for the feet a perfect square or is it a rectangle?
     
  5. mhe

    mhe Active Member

    Joined:
    Sep 5, 2015
    Messages:
    32
    Likes Received:
    3
    And the distance in the Y-direction?

    I currently have my Rigidbot Big on an Ikea drawer on wheels. It would be brilliant if I could keep that drawer. It is an Ikea "Alex" and it is brilliant as the printer stands on top and the lower drawers are a perfect fit for filament rolls. It also doubles as a storage space for my reloading equipment. Cheap and highly recommended.
     

Share This Page