Dock station crash after print completes

Discussion in 'Calibration, Help, and Troubleshooting' started by TstarkEngineering, Dec 8, 2016.

  1. TstarkEngineering

    TstarkEngineering Well-Known Member

    Joined:
    Jan 29, 2016
    Messages:
    450
    Likes Received:
    120
    Dual Hybrid.

    Crashes after print completes. It goes to the docking station properly, then once it is at the docking station moves to the left and crashes into the side.

    This script is there as well.

    ;dock
    T0
    G1 X70 Y200 F3000
    G1 X70 Y240 F3000
     
  2. Paul Begley

    Paul Begley Well-Known Member

    Joined:
    Mar 24, 2016
    Messages:
    81
    Likes Received:
    19
    Have you set the dual head offset?
    If you home, set the offset then issue a T0. Then T1, does it move the head?
    If so, sounds similar to my post below

    https://forum.e3d-online.com/index.php?threads/head-crashing-when-docked.2342/#post-25178
     
  3. kevclarx

    kevclarx Active Member

    Joined:
    Jul 8, 2016
    Messages:
    28
    Likes Received:
    4
    Question on this since I have same issue(on RC6 still). I set the offset in Octoprint but it doesn't seem to do anything, do you have to set it in S3d as well? Having a little trouble finding the right place to set this.
     
  4. TstarkEngineering

    TstarkEngineering Well-Known Member

    Joined:
    Jan 29, 2016
    Messages:
    450
    Likes Received:
    120
    For me it ended up being the profile in s3d that was the problem
     
    kevclarx likes this.

Share This Page