Does your extruder skip?

Discussion in 'Getting Started' started by blarbles, Aug 25, 2019.

  1. blarbles

    blarbles Well-Known Member

    Joined:
    Aug 10, 2019
    Messages:
    102
    Likes Received:
    64
    More armature hour tips:

    Did you open all your titan extruder boxes and dump the parts in a pile? Does your extruder skip/click/tear through filament?

    You may have done what I did - the idlers are specific to mirrored or not. White dot = mirrored. No dot = regular. The difference is the idler pin is flush on a different side. Took me a bit to figure that out.
     
    Spoon Unit, jfb and mhe like this.
  2. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,546
    Likes Received:
    481
    Good spot. But no. I did not go for the 'jumble sale' setup :) In fact my build process was to get a one extruder system fully working, then introduce a second tool to figure out multi-material. Once I sort that all out, tools 3 and 4 should be simple. Actually, I'll roll that back a bit. I did fit all the Titans, so I could have easily done what you did, but didn't :)
     
  3. Andy Cohen

    Andy Cohen Well-Known Member

    Joined:
    Aug 23, 2019
    Messages:
    217
    Likes Received:
    57
    Ouch. I'll be sure to build one at a time. I'm glad I thought to read every post here. Thanks for sharing.
     

Share This Page