Drag Chain on X-Axis

Discussion in 'Build Help' started by Old_Tafr, Mar 12, 2016.

  1. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    561
    Likes Received:
    75
    The chain only curls round one way, make sure you run it under the motor to the back of the frame before you clip it on the motor mount.

    Tip on running the cables through the chain. Once the motor cable is through (easy without using a pull through) pull it through further then push the end stop cable through the motor cables, through a twist of the red/black and then through a twist if the red/blue and then use the motor cable to pull the end stop cable back through quickly and easily.
     
    Mike Kelly likes this.

Share This Page