SOLVED Dual Hybrid wiring Step 25.2

Discussion in 'Build Help' started by gearmesh, Jun 11, 2016.

  1. gearmesh

    gearmesh Well-Known Member

    Joined:
    Feb 21, 2016
    Messages:
    162
    Likes Received:
    13
  2. gearmesh

    gearmesh Well-Known Member

    Joined:
    Feb 21, 2016
    Messages:
    162
    Likes Received:
    13
    Argg. Friggen Manual.
    I figured it out easy enough by putting a resistance tester on a on set of of yellow/black leads and then toggled the X switch. When I found the right plug I put it into X-. Then I did the same for the remaining yellow/black lead. Tested it first to be sure, and then plugged it to the Y- terminal.
     
  3. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    Fine you figured it out, though I must say the picture shows the connector in Y- port. I admit it is hard to see because the plug seems to reflect a bit but the PINs are from bottom to top: Z+, Z-, Y+, Y-, X+ and X- and counting the PINs from bottom the plug is in the fourth --> Y-
     

Share This Page