Separate names with a comma.
Discussion in 'Show off' started by gonzalo, Jun 26, 2016.
2nd finished print EVER from this machine, FIRST dual print EVER!
I am learning G code now
Looks very nice. PLA?
Yes, Orange is polymaker PolyPlus PLA and white is Afinia/Up! PLA.
And did you use the ram-purge script from Greg or an ooze-shield or both (getting ready to do the conversion over and will start dual at that point)
I did only ooze shield and it proved to be insufficient by itself; I guess there is a bit of science involved in producing a clean dual print, the ooze shield will prevent the INACTIVE nozzle ooze from reaching the print, but it will not help with the ooze of the ACTIVE nozzle. This is because the ACTIVE nozzle is confined inside the ooze shield, so it will ooze when it is traveling from the shield to the part.
I believe that the purge tower COMBINED with the ooze shield will work better, because it will hopefully force BOTH nozzles to travel outside the ooze shield on every layer and allow the shield to clean both nozzles.
I remember the video of Gregs dual vase but I can't find the script... Do you have it? Thank you!