Hi, I'm looking for some advice on where to look for the setting for the dump bucket. If I run the calibration g code that came with the SD card it goes to the ooze bucket perfectly and extrudes as it should but as soon as I run a print, after the print it tries to move to the dump bucket and stops short? Any ideas how or where to look to fix this? Is it in the G code itself? Thanks. I am using a Titan hybrid Pro
Yes, I had same problem with titan hybrid, I was using wrong firmware from Alex. Needed to use the one called 'mirrored' rather than the one without. That fixed my error, although it is in the tool change script if you want to edit the code there. Once I had that sorted it lined up perfectly.