Hi All, So I never really got into the 3D printing when I got my Dual on kickstater,, went for all of it!! Now I have some time on my hands I thought I would give it a go. So have plugged it all in and get it set up with slicer, octopi and.... now i remember why I didn't have the time to sort out things. I have a simplify3d profile I found on this forum for the Dual I have leveled the bed, - moved the IR leveled again. Tried to update firmware.... no luck as all docs are our of date, i'm on RC 3 1/ I auto home before all prints. 2/ hit print from octopi and then the first thing it does is crash whilst trying to get to the dock (sometimes) 3/ then hits the glass on the way out 4/ then dosen't stick to the glass So far I got 1 print that of a 2cm cube that well was a nightmare, each time there is something else wrong. Now I know i'm 4 years behind, but 1/ are there any updated docs for the dual 2/ how do i update firmware now plugins have moved on - there is now AVR MCU and AVE programmer Type... what should I put in these 3/ how do i get it to LEVEL and stick! keep using the paper trick and no luck! 4/ any better simplify3d slicer profile that is designed when using just one extruder!? (lets start with one) Any help greatly appreciated **UPDATE** Ok, so I added the same script from both to "extruder 1 only" ;BigBox Printer Start Script Begin ;extruder offset - refer to the wiki | http://wiki.e3d-online.com/wiki/Printer_Commissioning#Dual_Nozzle_Alignment M218 T1 X35 Y0 M117 Print Starting. ;BigBox Printer Start Script End It no longer seems to smash and docks properly Now it seems to have the second nozzle constantly scrapping the print away and I can't seem to get it to level and do the first layer. seem to close to the bed I have releveled about 100 times with thicker and thicker paper. I am hoping the newer firmware will help if i can get it installed
