Check out the Edge info and video: http://e3d-online.com/Edge Filastruder.com @elmoret is carrying the new E3D Edge filament in the US: http://www.filastruder.com/collections/filament/products/e3d-edge-filament
At the risk of sounding very girly, a white/slate grey BigBox with parts printed in dark crystal Edge would look very damn good indeed. Must resist temptation to reprint everything...
I was hoping that silicone boot would be available when edge was announced, I need that and scaffold and US shipping is on the high side.
Good job e3d ! And that haribo-scoop will look good in Racing Green.... ;-) ps btw. there are a few editing errors in the video in which PLA ("high temperature resistance....") & ABS apparently become confused...
I believe the performance qualitatives - and I can see it looks nice - the one thing I'm really curious about is it's "temperature resistance".... (Will be making some parts that need to contact hot cookware.) Probably the only way will be to invent some bending test and put it side to side with nGen / XT / HT....
Silicone boot should follow in about 4 weeks. Scaffold is out of stock for some weeks to come. We'll carry both at Filastruder as soon as they're available.
Ordered, ordered, and ordered... Red, White, and Grey! #FilaAddiction pretty sure I'm in need of an intervention!!! I really loved XT once I got it dialed-in, hoping that Edge is even simpler to setup. @elmoret must be busy!
In this photo (break test from the Edge page) is that the banding that you get when your Z-axis bearings deteriorate?