E3D Extruder Clicking

Discussion in 'Titan' started by Michael Wu, Dec 6, 2017.

Tags:
  1. Michael Wu

    Michael Wu New Member

    Joined:
    Dec 6, 2017
    Messages:
    1
    Likes Received:
    0
    Just installed an e3d titan aero on my wanhao i3 using: https://www.thingiverse.com/thing:2178694

    Everything went fine until I tried extruding, and all it did was click while the lever swung back and forth continuously. After some testing, I found that if I removed the spacer on the front bottom screw, so that it wasn't pushing on to the heatsink, it extrudes great.

    Is it possible my heatsink is slightly deformed in that area or is it some other issue?
     

Share This Page