E3D Heater ID 0 run away...

Discussion in 'E3D-v6 and Lite6' started by Andre, Jul 18, 2016.

  1. Andre

    Andre Member

    Joined:
    Jul 12, 2016
    Messages:
    14
    Likes Received:
    0
    Hello Guys,

    since last Week i got a Problem with my Heater (I think it is the Nozzle).
    The Temperature run away (Heater ID 0) if i print currently after a few Minutes > 10min.

    Heater_ID_0.PNG

    I use the old Heater/Nozzle/Thermistor Block where i have to screw the Thermistor in place.
    And i use a Bowden e3D V6 Bowden 12V, This Holder (http://www.thingiverse.com/thing:1632847)
    with the 12V radial Fan.

    I think maybe the Radial Fan cools the Nozzle to mutch but i don't know how to fix that...
    In the Attached Files you can see how the Temperature Diagramm looks.


    temperature_run_away_Heater_ID_0.PNG
     
    #1 Andre, Jul 18, 2016
    Last edited: Jul 18, 2016
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    631
    Likes Received:
    101
    You need to enable the fan a little bit at a time, like 20%, then on the next layer 40%, etc.
     
  3. Andre

    Andre Member

    Joined:
    Jul 12, 2016
    Messages:
    14
    Likes Received:
    0
    Ok, but how?
    I use Cura to slice everything and i know that Simplify 3D got those Features but got Cura those to?

    Ok i found only a Advanced option to set min and max percantage for the cooling.
     

Share This Page