Can anyone tell the the value in the marlin tables for the temp sensor on the E3D-v5 head as supplied from Filastruder made by E3D. Bob
Hi Bob, If you purchased it recently it will be a Semitec (#5 in Marlin). They are recognisable because of the tiny bead - about 1.5mm across. Our older HotEnds used EPCOS thermistors which have a larger (~2.5mm) are #1, but unless your HotEnd has been sitting around for 6+ months you are unlikely to have one of these. Hope this helps, Josh Fore information: http://e3d-online.com/index.php?route=e ... blog_id=19
Thanks. I purchased it with my Filawinder kit. I had purchased a MakerFarm 13v printer with their .40 Hexagon Nozzle. I have had several blockages due to heat creep on the nozzle. Thanks for the info. Bob