E3D Titan Aero - EEPROM & S3D Settings

Discussion in 'Titan' started by SpReeD, Jul 30, 2017.

  1. SpReeD

    SpReeD New Member

    Joined:
    Jul 30, 2017
    Messages:
    1
    Likes Received:
    0
    Hi@ll,

    I just upgraded to a titan aero, everything fine so far, but i was wondering if there are any percept settings, like acceleration, jerk etc.

    My Settings so far:

    [EEPROM]
    Steps: 420,00 mm/steps per unit
    Feedrate: 50,00 mm/rate per unit
    Max. Acceleration: 10000 mm/s2
    Retract: 1000,00 mm/s2
    Max E Jerk: 0,30 mm/s

    [S3D]
    Extrusion Width: Auto (0,48mm)

    Ooze Control:
    - Retraction Distance: 1,00mm
    - Extra Restart Distance: 0,00mm
    - Rectraction Vertical Lift: 0,00mm
    - Retraction Speed: 45,00mm/s
    - Coasting Distace: 0,05mm
    No Wipe Nozzle

    Fist Layer Settings:
    -Height : 90%
    - Width: 100%
    - Speed: 50%
    - Outline Direction: Inside-Out

    Speeds:
    Def. Printing Speed: 75,0mm/s
    Outline Underspeed: 50%
    Solid Infill Underspeed: 80%
    X/Y Axis Mov. Speed: 80,0mm/s

    [​IMG]
     
    #1 SpReeD, Jul 30, 2017
    Last edited: Jul 30, 2017

Share This Page