E3D Ultimaker 2+ Upgrade Kit FIRMWARE

Discussion in 'HotEnds & Extruders' started by Lawrence Taylor, Nov 23, 2020.

  1. Lawrence Taylor

    Lawrence Taylor New Member

    Joined:
    Nov 19, 2020
    Messages:
    1
    Likes Received:
    0
    Hey Makers,

    We have an Ultimaker 2+ Extended that I've just installed a new old stock E3D-V6 with Titan upgrade kit on. The only issue is that I can't for the life of me find FIRMWARE for the upgrade kit anywhere. I've found several dead links.

    I understand that there are several solution paths, but I like to start with the original firmware and then learn the other processes. They will all be new lessons for me.

    Clear Dark Skies,
    Lawrence “Bird” Taylor
     
  2. C___

    C___ New Member

    Joined:
    Nov 26, 2020
    Messages:
    1
    Likes Received:
    0
    Don't know anything about this specific upgrade kit, but did you try Archive.org and Archive.is for the dead links? Often even downloads are archived by them. Good luck!
     

Share This Page