E3D-v6 and Titan on Ultimaker 2

Discussion in 'E3D-v6 and Lite6' started by Mark TYR3d, Nov 6, 2016.

  1. Mark TYR3d

    Mark TYR3d New Member

    Joined:
    Nov 6, 2016
    Messages:
    1
    Likes Received:
    0
    I have the E3D-v6 head ready to go the Ultimake 2+ but do not want to use the Titan extruder. The Doc's information is for both. So if I do not use the titan will the firmware that it has up work with only the V6 head or does it change the gearing for the titan as well.
    I am new to the firmware side of things
     

Share This Page