E3D V6 Full with Titan direct extruder slic3r PLA Settings ?

Discussion in 'E3D-v6 and Lite6' started by nkef, Jan 16, 2017.

  1. nkef

    nkef Member

    Joined:
    Jan 11, 2017
    Messages:
    3
    Likes Received:
    0
    Hi,
    I just installed the E3D V6 Full with Titan direct extruder with the 42BYGHM208P4.5-15-X2 stepper motor on my 3D printer.
    I would like to ask if there is a full set of recommended settings for slic3r to start with?
    (Retraction Length, Retraction speed, Extrusion multiplier, e.t.c)
     
  2. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,561
    Likes Received:
    483
    You might want to read up here - https://wiki.e3d-online.com/wiki/E3D-v6_Troubleshooting
    Certainly, take note of the max retraction length setting of 2.5mm. I think mine is on 1.5mm.
    I use a retraction speed of 4500 mm/min, a 0.4 mm nozzle with extrusion multiplier of 1.00 resulting in an auto-set 0.48 extrusion width. This is in S3D though; I don't use slic3r. Maybe this helps you get started though.
     

Share This Page