E3D-V6 on a Da Vinci 1.0

Discussion in 'E3D-v6 and Lite6' started by Meggerman, Mar 14, 2017.

  1. Meggerman

    Meggerman New Member

    Joined:
    Mar 14, 2017
    Messages:
    1
    Likes Received:
    0
    I would like to install a E3DV6 on a Da Vinci 1.0 to improve print quality.
    But not sure if to go for direct drive or Bowden drive.
    I suppose I could start with direct drive then move to Bowden.

    Also should I flash the firmware to Repetier or stick with XYZ?

    Thanks
    Rob
     

Share This Page