E3D V6 UM2 upgrade firmware issue

Discussion in 'E3D-v6 and Lite6' started by lance, Dec 29, 2016.

  1. lance

    lance Well-Known Member

    Joined:
    Nov 25, 2015
    Messages:
    54
    Likes Received:
    9
    so i just got my upgrade kit for my UM2 and after installing it and doing some prints everything is fine although the heated bed wont heat up, it just sits at idle. I've been printing PLA so it hasn't stopped the printer at all but im just curious if the firmware update could have caused this issue?
     

Share This Page