Hello! I would buy the E3D v6 Direct for my Prusa i3 rework. I'm a beginner and i don't understand if this hotend can be good for the Wade's Extruder that i've. Is it compatible? Do you think I need extra parts to use it? Are there istruction to mount this on Wade's? My Wade's Extruder Kit: 1x Wade Extruder Body 1.75mm 1x Extruder Idler 1x Fan Duct 1x Wade Small Gear 1x Wade Bige Gear And are the same parts on the wiki of the parts for the Prusa i3 Rework. If you need some photos i can take them. Thank you.
It should fit okay, but you may need to use washers to ensure a tight fit between the Wades and the E3D.