Edge on Kapton

Discussion in 'Filament' started by pSimon, Oct 20, 2016.

  1. pSimon

    pSimon Member

    Joined:
    Sep 27, 2016
    Messages:
    23
    Likes Received:
    0
    Has anyone had any experience with this?

    My bed is glass+kapton, which has been fine for PLA and ABS with no glues, sprays or other condiments.

    I realise the recommendation is gluestick, but my results with them in the past have been mixed to say the least, and not having to reapply and degunk the bed is always a plus.
     
  2. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    I apply 3D Eez to glass, works for months, I only print in PETG and PLA pretty much I have heard it works with other plastics too.
     
  3. offroad

    offroad New Member

    Joined:
    Jun 2, 2017
    Messages:
    1
    Likes Received:
    0
    I started by using UHU Stick, but soon found that it's pretty unreliable. So I went back to printing on Kapton tape.
    So far its been a very nice experience...
     

Share This Page