Extruder speeds and temps

Discussion in 'E3D-v6 and Lite6' started by UKIan, Sep 30, 2014.

  1. UKIan

    UKIan Member

    Joined:
    Sep 7, 2014
    Messages:
    10
    Likes Received:
    0
    Hi, I'm using marlin and a bulldog extruder. The extruder can outrun the hot end (obviously), if you push filament through fast enough eventually it can't melt fast enough.

    What max extruder speeds are you configuring in marlin, and what temps are you printing pla/as at?

    Thanks
    Ian
     

Share This Page