extruder velleman K8200 Use aluminum frame and E3D

Discussion in 'E3D-v6 and Lite6' started by treblasnirp, Mar 25, 2014.

  1. treblasnirp

    treblasnirp Member

    Joined:
    Mar 9, 2014
    Messages:
    4
    Likes Received:
    0
    extruder velleman K8200 Use aluminum frame and E3D

    improvement:

    used, the stability of the aluminum frame.
    you can move the horizontal frame in the middle of the vertical frame.
    simply changing fillement.
    easily switch from 3 mm to 1.75 fillement by changing the base block (1,75 mm block in development)
    used the aluminum frame as an additional cooling.

    http://youtu.be/CXCkt8PJKaM
    http://www.thingiverse.com/thing:281085
     
    #1 treblasnirp, Mar 25, 2014
  2. AndersE

    AndersE Active Member

    Joined:
    Mar 30, 2014
    Messages:
    33
    Likes Received:
    0
    I will try this but i will remix it for even better stability and accessability.
     
    #2 AndersE, Apr 3, 2014
  3. treblasnirp

    treblasnirp Member

    Joined:
    Mar 9, 2014
    Messages:
    4
    Likes Received:
    0
    I look forward to a remix and wish you sucses.
     
    #3 treblasnirp, Apr 4, 2014
  4. AndersE

    AndersE Active Member

    Joined:
    Mar 30, 2014
    Messages:
    33
    Likes Received:
    0
    It will not happen in a while because i also have problems with jams. So i am following the thread about this problems to see what happens.
     
    #4 AndersE, Apr 22, 2014
  5. treblasnirp

    treblasnirp Member

    Joined:
    Mar 9, 2014
    Messages:
    4
    Likes Received:
    0
    That's why I made my own extruder.
    The extruder of k8200 is a waden spring extruder.
    My opinion is that the spring has only one function for a Bowden feed hotend.
    In a direct feed hotend you should not use a spring.
    I print 8 hours a day ABS and sometimes without heated bed but with magic tape.

    Cura settings:
    temp 245
    Heated bed first 5 mm 50 degrees below 0 degrees with magic tape.
    Or 0 degrees with magic tape.
     
    #5 treblasnirp, Apr 28, 2014
(You must log in or sign up to post here.)

Share This Page