extrusion stops too early

Discussion in 'Titan' started by MentalUproar, Feb 21, 2018.

  1. MentalUproar

    MentalUproar Member

    Joined:
    Feb 21, 2018
    Messages:
    3
    Likes Received:
    0
    I can't find any problems with the slicer settings, firmware settings, hardware, and it does this with every material. What could I possibly be missing?
     
  2. Antoine

    Antoine Well-Known Member
    Staff Member

    Joined:
    Apr 3, 2017
    Messages:
    117
    Likes Received:
    20
    Looks like a wrong wipe and/or coast setting. Set both to 0 and see if this changes anything? Which slicer are you using?
     
  3. MentalUproar

    MentalUproar Member

    Joined:
    Feb 21, 2018
    Messages:
    3
    Likes Received:
    0
    They are both at zero. I even disabled retraction. I’m using simplify 3d.
     
  4. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,561
    Likes Received:
    483
    Are you using pressure advance?
     
  5. MentalUproar

    MentalUproar Member

    Joined:
    Feb 21, 2018
    Messages:
    3
    Likes Received:
    0
  6. mulski6

    mulski6 New Member

    Joined:
    Dec 7, 2018
    Messages:
    1
    Likes Received:
    0

    Have you solved the issue yet?
    Can you upload the picture again. I think I have the same issue.
     

Share This Page