extrusion width

Discussion in 'E3D-v6 and Lite6' started by briggs, Jun 13, 2014.

  1. briggs

    briggs New Member

    Joined:
    Jun 12, 2014
    Messages:
    1
    Likes Received:
    0
    Just received my latest two V6 hot ends (ordered from Tim at Filastruder, great service, thank's Tim), and I love the new markings on the nozzles. Here is my question, given all the thought you put into tweaking the tip width/orifice length for each size nozzle, what are your recommendations for extrusion width for each nozzle size? And, do any of you out there vary this when going from .1 to .3 layer height? I have been pretty much using a 1.2 factor up until now - .35 nozzle size x 1.2 = .42 extrusion width, etc. I'm just curious if anybody has a better way of determining extrusion width.

    Thank you!
     

Share This Page