Filament change on BB Pro using S3D

Discussion in 'Calibration, Help, and Troubleshooting' started by Rajasundar, Apr 27, 2016.

  1. Rajasundar

    Rajasundar Member

    Joined:
    Mar 9, 2016
    Messages:
    8
    Likes Received:
    0
    Could anyone please advise me how to run a change filament option in the BigBox Pro using simplify 3d.

    I tried using the start/ stop distance feature on s3d and created 2 g codes and run one after the other. But the the second layers prints always with a small offset each time as attached pic. I don't understand where the problems comes from.
     

    Attached Files:

Share This Page