Finally ... nGen

Discussion in 'BigBox General Chat' started by Spoon Unit, Mar 7, 2016.

  1. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,561
    Likes Received:
    483
    Really struggling with nGen. It looks great as it goes down on the skirt, and then it just gets pulled up as it moves on to layer one. Then when it comes round again, it pulls it up again. Almost gave up. Cleaned the glass. Fresh UHU. Still no. All the time I know it's just inexperience. I try turning up the bed. Bingo.

    Printing now happily at 210, bed at 90 (too hot?)

    [​IMG]
     
    Mike Kelly likes this.
  2. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    251
    Likes Received:
    68
    I had some lifting and separating of layers, but printing at 230c and bed at 75c seems to be going well, but I did turn the fan down to max 50 which helped.

    The colorfabb site has lots of tips and recommended settings for different printers to give an idea of what else to change
     
    Mike Kelly likes this.

Share This Page