Firmware Frustration??

Discussion in 'E3D-v6 and Lite6' started by RCTech, Jul 6, 2014.

  1. RCTech

    RCTech Member

    Joined:
    Jul 6, 2014
    Messages:
    2
    Likes Received:
    0
    Hey guys,
    I just installed my new E3D V6 and in the marlin firmware changed the thermister type to 5 and I am getting temp readings for 739c and an obvious maxtemp error. I am running a Makerfarm prusa I3 with makerfarm firmware(modified marlin) Don't know if I need to upgrade firmware for this thermister or what else I am doing wrong. I was running a jhead mkIV. Colin at makerfarm is not familiar with the hotend or thermister.

    Thanks
     
    #1 RCTech, Jul 6, 2014
  2. Ralph Hilton

    Ralph Hilton Well-Known Member

    Joined:
    Feb 27, 2014
    Messages:
    46
    Likes Received:
    0
    I suspect that you have a short circuit in your wiring of the thermistor.
     
    #2 Ralph Hilton, Jul 6, 2014
  3. RCTech

    RCTech Member

    Joined:
    Jul 6, 2014
    Messages:
    2
    Likes Received:
    0
    The thermister was shorting out!! Should have checked that sooner :)

    Thanks guys
     
    #3 RCTech, Jul 6, 2014
(You must log in or sign up to post here.)

Share This Page