firmware upgrade for e3d titan and e3d extruder on a lulzbot taz 3

Discussion in 'Calibration, Help, and Troubleshooting' started by m4rtin, Jun 26, 2017.

  1. m4rtin

    m4rtin Member

    Joined:
    Jun 26, 2017
    Messages:
    3
    Likes Received:
    0
    I upgraded my taz 3 to a titan extruder with an e3d hotend, i am having trouble looking for the firmware to flash my taz 3 to run the titan extruder. I currently have a taz 4 that was upgraded to a e3d titan extruder and hotend, but it was purchased that way. All I want to do is copy what I have on my taz 4, any help will be appreciated. Thank You

    I may have posted this on the wrong section. I apologize
     
    #1 m4rtin, Jun 26, 2017
    Last edited: Jun 26, 2017

Share This Page