Flexible Octopus

Discussion in 'Show off' started by Alex9779, Jul 21, 2016.

  1. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,411
    Likes Received:
    735
    My very first NinjaFlex print.
    Had some first layer issues and had to stop at layer 1 and the next try at 3.
    Try 3 had feeding issues, I changed extrusion width and multiplier in the slicer but forgot to turn back the 130% I set on the box so also failed on layer 1.
    This is the result of try 4:
    IMG_0721.JPG
     
    #1 Alex9779, Jul 21, 2016
    Spoon Unit, moshen, mike01hu and 4 others like this.
  2. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    586
    Likes Received:
    100
    I have read that NinjaFlex and PEI is not a good combo. That it sticks too well.
     
    #2 Stian Indal Haugseth, Jul 21, 2016
  3. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,411
    Likes Received:
    735
    It was ok to get it off for this model...
     
    #3 Alex9779, Jul 21, 2016
  4. JesperJuul

    JesperJuul Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    108
    Likes Received:
    36
    Temps?
     
    #4 JesperJuul, Jul 24, 2016
  5. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,411
    Likes Received:
    735
    45° C bed, 225° C hotend, no changes over layers...
     
    #5 Alex9779, Jul 24, 2016
    JesperJuul likes this.
(You must log in or sign up to post here.)

Share This Page