Gecko Tek

Discussion in 'BigBox General Chat' started by KNM3D, Feb 5, 2018.

  1. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    194
    Likes Received:
    6
    anyone used this on a glass bed yet, bigbox or otherwise?
     
  2. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    194
    Likes Received:
    6
    my first print went great.
    mind you it was the 40mm calibration box.
     
  3. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    194
    Likes Received:
    6
    Prints great for me.
    the upside for $$$ since I got my packs off kickstarter for a cheap price.
    but for the retail price I would still go with build tak.

    since all I got from Gecko Tek from the kickstarter were the adhesive sheets, and no spring steel plates. so this will be a consumable until im out of the this surface.
    then ill upgrade to Build Tak system
     
  4. gonzalo

    gonzalo Well-Known Member

    Joined:
    Mar 17, 2016
    Messages:
    214
    Likes Received:
    125
    I have a sheet of geckotek on a spring steel sheet for the buildtak flex system. I use it exclusively for nylon, it sticks very well. I don’t think nylon likes the buildtak surface.
     
  5. KNM3D

    KNM3D Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    194
    Likes Received:
    6
    hmmm, good to know. thankyou.
     

Share This Page