Geeetech Prusa Pro B i3 upgrade to E3D V6

Discussion in 'Titan' started by Julian haines, Mar 21, 2019.

  1. Julian haines

    Julian haines Member

    Joined:
    Mar 21, 2019
    Messages:
    2
    Likes Received:
    0
    Hi,

    I have just upgraded my Geeetech Prusa Pro B i3 upgrade to E3D V6 + Titan combo which i purchased ready built designed for the printer.

    I have install and updated the firmware as described in the documentation but I can’t get the Titan to extrude, the V6 heats up well and I can manually push/extrude filament but a can’t see the motor doing anything.

    The motor came ready installed but I am thinking it may not be getting enough power?

    Has anyone had similar issues or can help? The main board is a gt2560 + do I need to do anything with the driver for the motor? I was thinking of swapping the motor of the one on my old mk8 to see if this helps but not certain how it will work with the Titan.

    Thanks
     

Share This Page