Gold e3d hotend

Discussion in 'E3D-v6 and Lite6' started by Alex Benz, Jan 10, 2018.

  1. Alex Benz

    Alex Benz New Member

    Joined:
    Jan 10, 2018
    Messages:
    1
    Likes Received:
    0
    So I have the new gold v6 kit but I don't have a printer for it. I would like to put it on a Delta something like a little monster any idias or opinions I would like to spend less then $ as I have the v6 but willing to go closer to $1000
     
  2. dc42

    dc42 Well-Known Member

    Joined:
    Aug 16, 2016
    Messages:
    245
    Likes Received:
    83
    Are you looking for a kit or a self-sourced build? If you are looking for a self-sourced build, you might consider my precision Kossel design, see https://miscsolutions.wordpress.com/dc42s-large-kossel-build/. If you want a kit that accepts the E3Dv6, then Think3DPrint3D is selling a limited quantity of a very similar kit (it uses 24V power for the bed heater instead of AC mains power, but it is otherwise based on my design), see the "Important message" at https://www.think3dprint3d.com/3D-Printer-Kits/Kossel-Mini-3dPrinter-Kit.
     

Share This Page