Groove mounth fitting

Discussion in 'E3D-v6 and Lite6' started by lavith, May 10, 2014.

  1. lavith

    lavith New Member

    Joined:
    May 10, 2014
    Messages:
    1
    Likes Received:
    0
    I am the owner of e3D hotend v5 direct drive and am thinking of getting the SeeMeCNC EZstruder extruder as my direct drive system. Does your product snugly fit EZStruder ABS injection molded plastic part? I checked your drawing of the groove mount against J-Head and it's a bit different. (I have a J-Head groove mount perfectly fit with EZStruder though)

    I search online and I havenn't seen anyone mounting E3D directly to EZStruder. I am a bit concerned here.
     
  2. Eaglezsoar

    Eaglezsoar Administrator

    Joined:
    Mar 7, 2014
    Messages:
    267
    Likes Received:
    0
    I think that a thin flat washer would need to go on the top of the E3D to push it down a little to fit in the EzStruder.
     

Share This Page